can I make one half of it? Will it still possess all of its sound quality except for the halved reduced spl and bottom end response?

Afternoon all,

My father and i have decided to try and attempt to build a couple of USB speakers as a little project over the next few weeks. Ive downloaded the plans and redrawn them in AutoCAD (i was bored. lol) to work out the remaining dimensions and angles ect.

No doubt ill have a few question for the members here in relation to this build over the next few weeks, but my first few are:-

1) What is the best way to wire USB's if they were to be used with their intended Labsub speakers, is using NL4MP. (could some explains the wiring to me in basic laymans terms lol)

2) I have redrawn the USB's with bar handles in the access panel, would this be ok? the bar handles are the self contained type, and i would be gluing and screwing them in to place so as to completely seal them?

3) Does anybody still make router templates for these ? any prices knocking about ?

Regards
Chris

what was your high pass set too......

can i ask for some help. we built a couple and when we tested it. it blew the drivers

its on the link directly above your last post.....

Hi can some 1 send me the plan for the usb i would like to bilud 2

http://www.freespeakerplans.com/images/ ... bplans.jpg

I would like to hear if somebody have the plan for this USB sub, because the link don't workThanks

yes just make them in half, minus off 9mm then add 18mm for the new end panel.... from the plan......

is possible to build a single speaker cab?