hi

i found this empty boxes, they are old, i bought them very cheap...the guy said they should play 100hz-2khz. i would like to use them above 18"folded horns from 140hz, and below 2"horn and tweeters...

on speakerplans people say they should be playing 250hz-1khz, thats too narrow for the use i have intended them for....if its not 100hz, it should be 120hz minimum
no problem cross them at 1khz, a 2"horn will go above

if u already saw this design please let me know something about it, first suitable drivers. they are old but never loaded, just stored in a room for years

size is 52x42highx72depht, good wood, quite heavy

back

front

I've done a few basic calculations taking in acoustic length if the horn was morphed into a round bottomed cone etc and the result was that it really won't go much below 250hz. Don't trust my maths though and work it out.

The MT12 section goes down to 120hz just about, check out it's dimensions.

Besides, with a dispersion like that, you'd need a fair few boxes anyways.

I pmed david asking for measurement of the cab... we have to wait for him. However it's quite similar to mt215 mk 2 or 3, isn't?

Besides, with a dispersion like that, you'd need a fair few boxes anyways.
[/quote]


i planned to have 2 of these in a stack, above scoops & folded horns and below 2"horns and tweeters

bitzo wrote:



i did the measurement today, but forgot to bring the sheet with me and will be back to the pc just tomorrow

its similar to this
http://www.ciare.com/pdf/Progetti/MyProf...nalSpeaker/mt010.pdf
http://www.ciare.com/pdf/Progetti/MyProf...alSpeaker/mt0100.pdf

but its 70cm long...

i know that incomplete info, but all these projects seem useful from 200hz anyway...