| MHB-4818 |
 |
 |
 |
Font Size 
|
Frequency: F3 = 46Hz/1 box, 40Hz/4 boxes Recommended driver:
Pictures:
Link to Forum Discussion [21 replies]
by xcn On which side is the access panel in this case, in case the driver gets fried and has to be taken out?
by bee you would load the driver in sideways from eather side...... so the acces panel can be put on the left or right side.......
by xmax extreme Does the V shape touches on the panel where the speaker is mounted? Or has a small clearance? I was wondering cause it might create some noise during bass vibrations.
by bee most w-bins load from the back, but look at the plans..... the driver sits on the inside of the rear chamber. You may be able to change the plan and load driver from the back.......
On second thoughts you cant change the plan as the v bit would then be wrong..... by bee the v bit sits level with the driver panal this would leave an 18mm gap to driver. 18mm being the thickness of the ply wood.
by xmax extreme thanks bee, how about on these portions, should be no gap between the tip of the V shape and speaker panel? please refer image below.
cheers  by bee looking at the plan i would say yes they do touch at both points you have marked out. done a quick rework of the measurments on paper. And again the v does touch the upper and lower part of the baffle, Hope this helps.
by xmax extreme Thanks bee, i am a bit worried if its not screwed, it will create some noise due to vibrations on the edges?
by bee screw and glue on the tip of the v bit, u could allso fill the void in the v with foam......
by tamuks what drivers did you use on this cab ?coz lm thinking of making 2 cabs using p.audio sd 18 and is it a long throw cab? .good work mate
by tamuks l did scketch measurement .the cab is rather too big .if lm to make 4 of them l will need a truck 2 carry them so can l make it for 15 inch speakers ? Do u have a plan for 15 inch drivers
by mautopsy "kentech" wrote:
can it be resised for a 12" woofer ?
Quick Reply
Please log in to post
|
LF18G401 Spec Sheet (
